This walk-through example will encourage you to build an Apache Camel application from scratch, deploy it in a Kubernetes environment, gather metrics using Prometheus and display them in Grafana. Monitoring will automatically adjust when the system scales up or down. Table of Contents Introduction About Prometheus To-Do overview Scraping data The application Enabling Prometheus Enabling […]
Category: Integration
Everything related to Integration Scenarios
A dear colleague of mine provided me with a Texas Instruments Sensortag Unfortunately this present was connected with the request to get it running with my Intel Edison and the Smart Gateway. This blog will be part one of my endeavor. Update the Intel Edison My Intel Edison still runs the old firmware, so the […]
This blog will cover my first experiments with an Intel Edison, a small Computer-on-Module, which Intel was so kind to give to me! Thanks again for this guys! There are many websites explaining how to setup your development computer to work with an Intel Edison, like Intels own website. So I will assume you have followed […]
This is part 5 of my IoT series of blogs. So far we did look at the following topic Introduction into the planned scenario Building a Raspberry Pi based Smart Gateway ESP8266 and DHT22 based smart sensor Putting the Smart into the Smart IoT Device Setting up an “all in one” demo environment This post will […]
If you have followed my earlier posts, then you know, that I’m in the process of building an IoT Demo, with a Raspberry Pi2 as the Smart Gateway. During this process, I had to re-install my Raspberry multiple times, but after the second time I got a bit tired of doing the same steps over […]
This is part 4 in my IoT series of blogs. The first parts did cover the following topics: Introduction into the planned scenario Building a Raspberry Pi based Smart Gateway ESP8266 and DHT22 based smart sensor This blog will describe how to enable the Smart Gateway to handle, enhance and forward incoming messages. As for […]
This is part 3 in my IoT series of blogs. The first parts did cover the following topics Introduction into the planned scenario Building a Rasperry Pi based Smart Gateway In this article I will describe how I build my first physical sensor, based on an ESP8266 microprocessor and a DHT22 digital temperature and humidity sensor. […]
As described in my previous post, my intention is to create a new version of my IoT Demo. The first element that I wanted to get up and running is the Gateway, which is supposed to run a MQTT broker to receive and forward messages a transformation capability to change messages, enable smart routing of […]
After having done a pure Docker/JBoss based IoT Demo-Environment I felt like it was time to bring this demo to the next level, but what does that mean? For me it means to become a bit more “realistic” and to integrate more and different technologies into the demo. In hard facts, this mean real, “dumb” […]
What it’s all about This demo is supposed to show a lab-based version of a typical Internet of Things ( IoT ) setup. It follows a 3-Layered architecture of Edge: as created of data Controller: first level of data processing Datacenter: well, the datacenter … These layers can – and in this demo will – […]